1
0
-1
With JMF Resource Messages the ExposedMediaElement is partitioned by SignatureName, SheetName, Side, Separation … Each Level has a Status Attribute. Does Status="Available" on Sheet-Level indicate that all separations has been exposed?
    CommentAdd your comment...

    1 answer

    1.  
      1
      0
      -1

      Correct, indicates all Sides and Plates were exposed. Note that for spot colors, prepress may report a different separation name that provided by MIS (Pantone extensions, or generic Spot1 replaced).

      Typically the messages would only send the delta with the previous message. If the last plate for one Side was exposed, the ExposedMedia and Part should the Status of that side then to Available to indicate it was the last (expected) plate.

      Remaking a plate is a bit special, the higher level Status remain Available then.

        CommentAdd your comment...